How to Jarvis

Jarvis assembly video

Please note: We’ve made updates to the Jarvis frame and this video is best used as a general assembly guide. The assembly instructions included with your Jarvis frame is the most accurate way to build your new desk.

Jarvis Crank Powered assembly video

Jarvis troubleshooting

Reset proceedure

If your desk is not functioning properly, such as only going down, or if your Memory Preset Handset reasds "RST," perform the reset proceedure shown below.

If there is a difference in height between the two legs that exceeds 1.5", stop the reset proceedure and contact Fully.

Motor/Voltage information

Control System
Model: JCB35N2-110
Input: 240V~ 60Hz, Max.270W
Output: DC 24V 4A/Linear actuator
Duty Cycle: 10%, Max.2 min operate/Min.18min stop
Used with Linear Actuator
Indoor use only, Install in type 1 environment
For use in pollution degree 2 environment


Memory programming

To programme up to four presets (on some models): Use the up/down buttons to find a desired height, then press "M" , followed by a number 1-4.